Like how you made the circles! More than one way to get the same result... I find the offset tool allows me to get the same result that's fast and repeatable! Great work!
@jurgenbergman6887
3 жыл бұрын
Darn... Now my little diode laser have to work a lot. Love that!
@DIY3DTECHcom
3 жыл бұрын
LOL! Watch this Wed as I will release a video on this being created...
@greggonzales2311
3 жыл бұрын
This was helpful! You should do more videos on lightburn.
@DIY3DTECHcom
3 жыл бұрын
Love LightBurn, any areas you would like me to cover?
@greggdrennan
3 жыл бұрын
Offset, group and weld would make this even easier...but both was work. Nice job on the video.
@electronron1
3 жыл бұрын
good timing. I've been making ornaments on th K40 for the last two weeks. I hadn't thought about making a state map (Michigan of course).
@DIY3DTECHcom
3 жыл бұрын
Cool!
@arthurschwieger82
3 жыл бұрын
Did you remember that you can hold the shift key while drawing your circle or a square to keep it a circle or square regardless of where you move your mouse. Like the video. Thank you for doing this.
@casualdanger
3 жыл бұрын
Just days after I finished making about 20 ornaments this comes out.
@DIY3DTECHcom
3 жыл бұрын
Time for 20 more :-)
@TT-qb2oj
2 жыл бұрын
Thanks
@JoePalumbo221
3 жыл бұрын
I love using lightburn. It helped me out of a pickle the other day.
@DIY3DTECHcom
3 жыл бұрын
I wish they had a CNC version! Would buy in in a heart beat!
@Scarekrow24
3 жыл бұрын
Instead of making two circles, why not use the offset function?
@mattgoldsworthy4376
2 жыл бұрын
how do you hollow out the center of the ornament? This was amazing and extremely helpful.
@Nobody000x
3 жыл бұрын
Which keys you used on the 1:55?
@loganwolf1359
3 жыл бұрын
Trying to figure out how to make a wooden coin with graphic and text in the middle (text going around the lower right corner) and then cut it out. But the program seems to want to connect the inner and outer circles as one process, meaning if I have the laser at 100% to cut the outside, it's going to do the same on the text and inner circle. Is there a way I could have the text be there at a lower power to just etch and still do the cutout around the outside? Thanks.
@Dancopymus
2 жыл бұрын
Your question isn't clear, but use layers with different colors for each thing.
Пікірлер: 19