Oh Yea! Please add support for Plotter 👍 I have CO2 Laser, Galvo Laser with Lightburn but on my Plotter I have no real cut software. And I think difference between Plotter and Diodelaser is not so big (both work over RS232 via USB). Just add knife trail around the corners. 95% of work are already done at lightburn 😉
@DerekMellottphoto
Жыл бұрын
I wish you offered a design only license. I run a CO2 and a fiber laser out in my shop and they each have their own computers so that uses up both of the installs for my license. If I want to do any design work I need to heat up my shop and head out there, I'd rather stay in my office and design in there.
@lightburnsoftware7189
Жыл бұрын
Have you ever emailed us? We’ll add a 3rd seat to your license for free, and more for a small fee.
@MakerMeraki
Жыл бұрын
@@lightburnsoftware7189 that's good info to know! I'm in a similar situation. Thank you!
@michaelkeymont501
Жыл бұрын
Same thing here - 2 machines, each with their own laptop and 1 machine in the house for design work. I might reach out about a 3rd seat… thanks!
@garys6583
Жыл бұрын
Same here , used up my two and then seeing this video had me thinking about design stuff while not connected to a laser engraver- nice option
@DerekMellottphoto
Жыл бұрын
@@lightburnsoftware7189 I haven't but I will. Thanks for the reply!
@DH-jf5yx
Жыл бұрын
Nice! I was wondering if I could buy this without a laser or not. Thanks. BTW, your voice sounds familiar. Is this ModBot from KZitem?
@MakerMeraki
Жыл бұрын
You are correct! 😁
@lightburnsoftware7189
Жыл бұрын
It is :)
@spudglynz
Жыл бұрын
As Derek said, a design license would be amazing. My main computer is never going to be connected to a laser. A discounted license that doesn't output would make life so much easier.
@lightburnsoftware7189
Жыл бұрын
If you email us with your license we will add a 3rd seat to your license for free, and more for a small fee.
@PhilippinesDarrellCheeks
Жыл бұрын
Awesome !
@CryoftheProphet
Жыл бұрын
I literally use Lightburn in conjunction with illustrator just because it has great design features, I dont even use it with a laser, I have an epilog so it doesnt work with that.
@ssrealestateserviceinc.5064
9 ай бұрын
what if you dont have my laser in the dropbox i have a d1pro 5w xtools
@lightburnsoftware7189
9 ай бұрын
It’s just a standard GCode laser, compatible with GRBL firmware. XTool also provides full instructions and a downloadable preset device with all the required settings on their website.
@jefflohner4216
Жыл бұрын
what happens if you change to another computer for the license? do you need a new license?
Пікірлер: 23