This shows an application that is difficult by hand but easy with the Fanuc co robot using the LightWELD system - doing a butt weld on steel without burning out the start point. This is done by lowering the laser power at the beginning of the weld then setting a higher laser output about .300 into the material - then lowering the power and ramp down at the end of the weld. The Fanuc CRX - using the LightBOT AP - has full control over the weld parameters and can change power in milliseconds. By hand you are stuck with one power setting - with a Fanuc Co Robot powers can be changed anywhere in the weld.
Негізгі бет LightWELD Fusion Welding Auto Part Can with Fanuc Co Robot
Пікірлер