This was exactly what I was looking for!!! Great. Very hard to find videos that demonstrate how to manually cut curved patterns in Forbo-linoleum on KZitem. Beautiful result!
@marcellschaid2850
2 жыл бұрын
Schön so etwas zu sehen tolle Bodenleger
@Polarfairy666
3 жыл бұрын
Sehr schön gemacht! Sehr inspirierend für ein eigenes Anti-Fliesen und Anti Holzoptik Kreativ Projekt für zu Hause...
@brianwild4640
3 жыл бұрын
Sehr gute professionelle Arbeit aus Großbritannien
@karlmachtnix9710
7 жыл бұрын
Meinen Respekt 👍💪🥇
@adriancolompar5157
3 жыл бұрын
sehr schwierig und kompliziert, mehr Farben zu setzen
@bailahie4235
3 жыл бұрын
What is the material you use to guide your pen along a smooth curve, it seems some flexible wire. What is it? Where can I get it?
@teofhuaromo
3 жыл бұрын
Excelente trabajo
@carolhanley7307
3 жыл бұрын
Bravo master
@JuergenKnebel-oc4sg
Жыл бұрын
Also ich habe bestimmt 15 Jahre, Lino verlegt. Krankenhäuser mit Hohlkehlleisten mit Innen und Außenecken, fräsen, verschweißen. Hochachtung vor dieser Verlegung. Vorallem die Schweißarbeiten. So etwas
@JuergenKnebel-oc4sg
Жыл бұрын
Würde ich mir nicht zutrauen.
@robertsol9007
3 жыл бұрын
Lot better than lazy american forbo certified installer!!!
@michaelperez5172
4 жыл бұрын
Who would thumbs down this ??? Crazy
@toddvierra1630
7 жыл бұрын
give these guys some Turbo Tools
@brianwild4640
3 жыл бұрын
they dont need turbo tools. turbo tools are just overpriced. and don't speed up a job like this
@mikhailbogdanov8486
4 жыл бұрын
Класс!
@heiko9922
8 жыл бұрын
perfect^^
@MrTomek7924
5 жыл бұрын
Pięknie
@altanaltay7040
3 жыл бұрын
@28:45 Challenging design and you guys did a good job but this freehand grooving is not a proper job. There are Turbo tools for both Lino & PVC products which is way faster and better results even better result than Leister Groover, no dust no noise no power needed. I would strongly recommend Turbo tools.
@brianwild4640
3 жыл бұрын
turbo tools for marmo are very poor soon as they start to dull the damage the marmo
@devonwoodman1523
3 жыл бұрын
Turbo tools are overpriced too, I’ve been freehand grooving for years and I’ve never had any problems doing it
@altanaltay7040
3 жыл бұрын
@@devonwoodman1523 I agree on over pricing but results are none comparable; consistency and time-wise you save money. Once you buy them you will gain profit in the next project but it depends on the volume of the job and budget issue. If you are doing small jobs, yeah freehand grooving may well be enough but if you have thousands of LF of weldings to do definitely worth to invest your money on Turbo tools.
Пікірлер: 22