I use the LN25 and I just wind it around the spool of wire so simple👍
@sullysuvann1380
4 жыл бұрын
i just wrap it around the spool
@johnw4590
6 жыл бұрын
Hmmmm. Just coil the sense line in a 4"circular loop. Then take the little work clamp to hold the coiled wire on the handle? Been doing that for years. (Still have original Lincoln clamps and cables..)
@ze_german2921
6 жыл бұрын
I have an Old SAE300 Could I use one of these to weld Sheet Metal?
@johnw4590
6 жыл бұрын
ZGERMAN Yes. I have 2 of them. Get .035 drive rolls and guide tube put .035-.045 liner in mig gun hook up 75/25% gas and a cv power source. I run my ln25 on a 305d or v350 invertec ( stay away from pulsed mig power sources because it could damage the pc boards of the ln25.) I run .035 hard wire up to 5/32nd flux cored wire. They are rugged portable and do a lot of heavy equipment repair use it in the shop or out in the field.. very versatile feeder..
@kikelozano2545
5 жыл бұрын
I got a question about this unit...can be hooked up to the miller 325 trailblazer?....thanks
@kentgardner8836
5 жыл бұрын
I use mine with a miller bobcat all the time. You set the selector on your 325 to wire, with the polarity set to negative and the polarity on the ln25 to negative and mine welds great. It works best if you set your starter switch to high rpm rather than run/idle
Пікірлер: 7