For a good seal that’s watertight in 5 mins always apply a bead 2 threads in on the female thread as well as the male thread....👍
@СергійВойко-з2й
11 ай бұрын
Доброго дня. На скільки років вистачить цього герметик після його полімерізації?
@izmirfication
9 ай бұрын
Hi just wanna know If I could use this instead of ptfe for a screw in heating element in a boiler tank, any cons or pros over teflon tape in practice , Thanks
@Retromaniabelgium
6 ай бұрын
Can this be used while the treads are wet?
@antoniogalluccio4213
2 жыл бұрын
So, shall I test after half an hour or after 24 hours? Can it do Natural Gas?
@PROinstal
Жыл бұрын
Siła przyzwyczajenia większa niż instrukcja musiał dociągnąć
@jacekkacprzak4551
Жыл бұрын
You don't use loctite activator first?
@tooltipsuk8799
Жыл бұрын
You can but its not required for a water tight seal
@fatihkocabas5178
3 жыл бұрын
hi, i have a small mobile phone lens that has been glued with an adhesive that i don't even know what adhesive it is attached to. How can I reduce the effect of this adhesive in the easiest way? because I have to clean the lens.☺️
Пікірлер: 11