Good to know its not just me having a pig of a job getting those cam carrier bolts out and that it needs that special tool. Your videos are keeping me sane at the moment ;-)
@MotoMirius
5 жыл бұрын
Ha! No you are not alone. One day I’m going to get back and finish this properly and gain back the bench space in the shed. Good luck! Skäl. David
@waitersluvhjy66
6 жыл бұрын
My works too. Used inplix handbooks and build it with no problems.
@springy-2112
7 жыл бұрын
coming along nicely Dave happy Christmas buddy
@MotoMirius
7 жыл бұрын
Thanks. Hope have had a great Yule too.
@KarlTheDingbat
7 жыл бұрын
Happy crimbo mate, hope you had a good one, starting to clean up nicely there.
@MotoMirius
7 жыл бұрын
Thanks, had a good time and hope you've had a great Yule too.
@bobbyblueace
5 жыл бұрын
Good work! The degreasing was so frustating to watch though. Forget white spirit or parrafin based degreasers for ground in oily dirt it's ineffective and expensive. Have you tried Mr Muscle spray on oven cleaner? I would recommend it. Spray it on but don't leave it too long on aluminium, max 20 mins, agitatie and wash off with hot soapy water. It's a revelation and cheap as chips. Thick rubber gloves are mandatory and eye protection advisable, though although it is caustic its not as noxious as the can would have you believe.
@MotoMirius
5 жыл бұрын
Cheers for that. Great suggestion I will bear in mind next time I need to do something some heavy degreasing 👍. Skäl. David
@volgnit
7 жыл бұрын
Another step on the journey.
@MotoMirius
7 жыл бұрын
Cheers, it's been slow but at least it's moving again.
@demofilm
6 жыл бұрын
Is there a gasket between the head and cilinder?
@MotoMirius
6 жыл бұрын
No gasket. It is one reason you should lap the barrel into the head - so that it seals properly.
Пікірлер: 13