🔗 www.MrD-RC.com 🔗 / mrd_rc
In this video, we finish off setting up our RC airplane. If you didn't see the first video, I would recommend watching that first. There we set up the transmitter model, bind the receiver, and get the receiver installed in the plane. • LoS Beginners: Setting...
This time we are finishing off the control surface setup. We will set the throws, then add rates to get the recommended throws for the model. We will also add some expo to make the centre stick less twitchy. The ESC will be calibrated and the propeller direction checked. And we will make sure that the plane balances on the recommended CG.
✈️ Contents ✈️
00:00 Introduction and recap
00:56 Checking out some important details in our manual
02:25 - The Centre of Gravity, or CG. One of the most important things to get right
03:40 - Suggested control surface throws
05:46 How to adjust the throws, a very basic look at control linkage geometry
10:06 How to adjust the centre position of the control surface
10:41 Demonstrating how to set the throw, using the aileron as an example
12:00 Rulers can be used, but throw gauges can be easier
13:03 Demonstrating how to get the control surface centre correct
14:44 A little tip for clevises
15:45 Setting triple rates in ETHOS
19:24 Setting expo for our trainer
21:50 The setup of advanced multiple expo settings, for aerobatic planes
23:57 Calibrating the ESC
25:24 Checking the motor is spinning in the correct direction
27:30 How to reverse the motor if it is spinning the wrong way
28:24 Checking the CG is correct
30:01 Final checks and conclusion
Thank you for watching this video. Time is precious, so I hope that you got some benefit from this video. If you have any questions, please leave a comment and I'll do my best to answer. Please try to keep questions relevant to the video in, as they may also help others who have the same question.
✈️ In this video ✈️
⚙️ FrSky Tandem X20S transmitter: bit.ly/MrD_3x6n6JL
✈️ Help other RC pilots find this video ✈️
If you found the video useful, I'd appreciate a thumbs up. This will help KZitem share this video with other RC pilots who may find it helpful. If you would like to get more videos when they become available, please subscribe and click the notifications bell icon. If there are links above, they may be affiliate links. If you click them, it will help me and my channel at no additional cost to you.
✈️ Supporting me and other resources ✈️
🛩 There are more tutorials on my web site at www.MrD-RC.com.
🛩 You can also join like-minded people at the Fixed Wing RC Rebels group and INAV Fixed Wing Group on Facebook.
🛩 Join the channel's discord server at / discord
🛩 Liking the video, subscribing, and clicking the bell icon can help greatly. This shows KZitem that the video is helpful, so it will be shown to more people, who may have the problem dealt with here.
🛩 If you found my video useful, you can become a Patreon at / mrd_rc
🛩 If you prefer, you could always buy me a Coffee at www.mrd-rc.com/go/ko-fi/
🛩 I also have merch at mrd-rc.creator-spring.com/ This include branded items as well as general fixed wing RC apparel.
Thank you for your time, and don't forget to fly it like you stole it!
Негізгі бет Тәжірибелік нұсқаулар және стиль LoS Beginners: Completing the basic model setup
Пікірлер: 25