Checkout our newest giveaway: bit.ly/Angling-Buzz-Giveaways
How to raise and lower your 17 foot, 21 foot, and your 24-foot Yetti fish house for this upcoming ice fishing season.
I'm going to walk you through the steps for the new user, or the old user that just upgraded to the new hydraulic system on the new Yetti fish houses.
Once you have found your spot you want to set up on the first step is to turn your remote on until you see a blinking green light that ensures that connectivity to the hydro unit inside the house.
Once you confirm that the remote is connected you’ll then want to find the pins that lock it into the frame.
There are two, one on each side. It is above the last wheel on the hydraulic frame.
Once you find these you want to use your remote and barely raise your house so it takes the pressure off the pins. Then remove the pins.
You will need a few clicks on the remote to raise the house enough to release the pins.
Do this on both sides.
Once you have the done you do not want to lower the fish house yet.
Next, you will go up to the tongue and remove the pin from the tongue.
Once you have removed all three pins you are able to drop your Yetti fish house completely to the ground.
At this point, you can disconnect from the Yetti Fish house from your truck or SUV, or you can leave it connected but once the house is lowered you are good to go and ready to fish.
Don't forget to grab your fishin' gear at your local Fleet Farm store or online:
bit.ly/fleet-farm-fishing
Негізгі бет Спорт Lowering and Raising Your Yetti Fish House
Пікірлер: 3