The PPU ammo loaded for the M1 is a lot cheaper than the AE and just as good.
@cornfromajar3222
7 ай бұрын
I haven’t been able to find any in my area. I will keep a lookout. Thanks for coming by!
@OliverCloseoff69
4 ай бұрын
Isn't that ammo a little to "hot" for the Garand? Do you run an adjustable gas plug? I'm inexperienced and don't want to damage anything. Thank you
@westcoastplinkin6559
4 ай бұрын
@@OliverCloseoff69 As long as you get the PPU that is specifically for the M1 Garand you should be fine. I have been shooting that for years and never had a problem.
@jameslaird5303
3 ай бұрын
@@OliverCloseoff69 -- PPU ammo for the M1 Garand (specifically so stated on the box) 150 gr is a-okay and is carried by both Lucky Gunner and Aim Surplus Just picked up 400 rounds, 200 from each.
@karlheinzvonkroemann2217
4 сағат бұрын
PPU IMHO makes very good Brass cased/Boxer primed ammunition thats a little on the hot side, not terriblly hot though but good quality good ammo in several popular WW2 time calibers. It's Serbian ammo so our State Dept presently doesn't like Serbian policies towards Kosovo. A newly created nation-state, created during the war because the Axis powers needed ammuniton and people living there needed work. A pretty simple marriage of convience really. Yugoslavia broke up the 1990's for some silly unknown reason. like religous and or ethnic hatred Back during WW2 the Germans sent some machine tooling down there and also to Romania. In addition to making Yugo Mausers, Yugoslava also made ammunition in 7.92 mm x 57 mm, 7.92mm x 33 mm, (8mm kurz) . 5.45 mm x 39.5mm. 30 06 caliber and possible also 3 08 caliber.
@tinman8518
7 ай бұрын
Great video! I bought some Sellier & Bellot Garand Ammo last year for much cheaper. Doesn't come up for sale too often though. I just love watching the M1 in action.
@cornfromajar3222
7 ай бұрын
Thanks for coming by!
@macy725
2 ай бұрын
I tried buying this but then turned around and bought the gear to reload it 💀 the cost of a box of ammo was the same as the dies and trimmer to reload 30-06. With the trajectory of ammo prices it won't really be financially feasible to keep these rifles fed for most people unless you reload.
@cornfromajar3222
Ай бұрын
Thanks for coming by!
@richardflora5173
5 ай бұрын
Just reload it 150gr bullet with 43gr of hod 4895 or imr 4895 very safe in a Garand they were designed to work in about 2700 fps out muzzle been doing this over 30 years. I NEVER GO OVER 168GR BULLETS with 45gr of hod 4895 or imr 4895.
@cornfromajar3222
5 ай бұрын
Thanks for sharing and thanks for coming by!
@airground1
3 ай бұрын
Lol you are shooting your rifle with the equivalent of training wheels. M2 ball was 2805fps MV so your 2700 comment is wrong. They were designed for 174grn bullets so your 168grn comment is also wrong.
@dragracingrule
4 ай бұрын
I feed mine Remington core lokt. From what the garand guys say is they’re about the same rating as m2 ball
@cornfromajar3222
3 ай бұрын
Thanks for sharing and thanks for coming by!
@kalan4787
7 ай бұрын
Get that elbow up!
@cornfromajar3222
7 ай бұрын
Thanks for coming by!
@kalan4787
7 ай бұрын
@cornfromajar3222 any time. Now get that elbow up 😋
@toastedfish996
2 ай бұрын
What a waste 45 bucks for that, I can find it online for $1.10 a round.
@cornfromajar3222
Ай бұрын
Thanks for coming by!
@mr.horseshoe2301
7 ай бұрын
Thanks for the video. I hand load 30-06 for about 35 cents a round. The most expensive part is the brass, but I collected around 1000 cases for free over the years from the local public range.
@cornfromajar3222
7 ай бұрын
I’ve noticed that my range that people generally don’t leave the expensive calibers laying around your fortunate that you were able to find some. I don’t reload myself I haven’t made the investment in the equipment. Thanks for coming by!
@VCBird6
6 ай бұрын
You must have gotten lucky and had a load of powder stores up Most of the powders safe for the Garand have gotten INCREDIBLY expensive to the point that just the powder load can run up over 35 cents 😢
@hardball107
3 ай бұрын
That's pretty cheap when a primer is .10c, powder .30c and a fmj bullet costs .30c. $.70 and that's with free brass in today's prices. At $.35/round I'll take 5000 rounds right now and kick in a bonus.
@dougrogers835
2 ай бұрын
I don't know why but it looks really awkward shooting that riffle left handed. Any issues?
@cornfromajar3222
Ай бұрын
Not really, you’re the first to mention that. Obviously the safety is a breeze, but working the bolt If I have to rack a round manually sometimes is awkward but other than that, it’s OK. Thanks for coming by!
@excatholicatheist
Ай бұрын
why would you load like that?
@cornfromajar3222
27 күн бұрын
1. To conserve ammo. When I woke up at 48 round clip, I’m too tempted to blast away. 2. I was hoping to teach others this technique. They may not know to load a few rounds at a time in there. Thanks for coming by!
@michaelbarfield528
8 ай бұрын
That ammunition by Federal has been discontinued.....☹☹☹
@cornfromajar3222
8 ай бұрын
You’re kidding?? Must have been stockpile then. I just bought it right after the first of the year. Thanks for coming by!
@michaelcannizzo1076
5 ай бұрын
@cornfromajar3222 confirmed. They also cancelled their M1A Socom/M14 safe line as well...
@Belowtheprairie
5 ай бұрын
Because any 150 grain ammo is fine lol
@brianlinville5420
4 ай бұрын
@cornfromajar3222 I just bought the same ammo from midway usa a week ago. So they are still making it
@redtra236
2 ай бұрын
@@michaelcannizzo1076 Can't any SAAMI spec .308 or 7.62 NATO be used in an M1A?
@tdethloff4696
6 ай бұрын
I had a catastrophic failure of my M1 while using a Schuster gas plug and hunting Ammo. It blew out the back end of the receiver and gave me a black eye. If I wasn't wearing eye protection, I likely would have lost it. I highly recommend people stick with 30-06 Ammo marked "For the M1 Garand."
@SamCulperJr
6 ай бұрын
Can I ask what loads you were shooting.. and if you actually adjusted your ADJUSTABLE gas plug lol. Or did you have it in tight as hell?
@tdethloff4696
6 ай бұрын
@connor3925 I was using Sellar & Bellot 180 Grain loads. I remember in the instructions of the Schuster gas plug that you start making adjustments first with the screw almost backed out. (Allowing all of the gases to escape, and not cycle the op rod.) You then gradually screw it in tighter, usually a turn at a time, and then fire a round, you keep making adjustments until the action cycles reliably.
@SamCulperJr
6 ай бұрын
@@tdethloff4696 ok ok 180gr is up there… So ur saying that you used 180gr 30ought With the plug “loose” and it still BLEW OUT your receiver?!?!?
@tdethloff4696
6 ай бұрын
@@SamCulperJr Yes... and to be clear, the accident happened probably between 70 to 80 rounds fired of that ammo. I'd be happy to send you a photo of the damage. Now I'm sure that I did something wrong in the adjustment, but I'm not taking chances anymore. I've since rebuilt the rifle and I've been using M1 Garand approved ammo ever since.
@SamCulperJr
6 ай бұрын
@@tdethloff4696 I hear you on that one friend, Yeah I’ve been watching and reading every bit of information I can on this gas plug. Bc I have my ‘42 Garand completely original that I’m terrified of damaging. If you’d be down yeah I’d love to see the pics of what happened. 70/80rds hmmmm I wonder if your rod spring was severely worn Was the spring “ok”? And what did you do between those 70-80rds Any adjustment?? Bc it was “fine” 50rds in. But between 70-80. What changed
@KyloRen-2010
3 ай бұрын
How much is the m1 grand?
@cornfromajar3222
3 ай бұрын
Prices fluctuate. If you go to a gun show you’re going to pay $1000 easy. If you get one from the CMP, just check out the website with rifles sales. Usually you can get the be much cheaper, depending on the grade. Thanks for coming by!
@crippleguy415
4 ай бұрын
PING ! 🤣👍🏻❤
@cornfromajar3222
4 ай бұрын
Thanks for coming by!
@airground1
8 ай бұрын
Pretty much all commercial ammo is garand safe
@cornfromajar3222
8 ай бұрын
Thanks for coming by!
@shawnreynolds8879
6 ай бұрын
No it is not you better read some on ammo and operation of the rifle .
@airground1
6 ай бұрын
@@shawnreynolds8879 already have.. that's how I know it's safe.
@shawnreynolds8879
6 ай бұрын
Go ahead and destroy your M1 I won't.
@airground1
6 ай бұрын
@@shawnreynolds8879 It's not going to hurt it. Commercial ammo is fine in garands.
@granoahbar
Ай бұрын
All fun and all, but unnecessary expenditure could be avoided by using literaly any 30.06 round in the 150-165 grain range
@cornfromajar3222
Ай бұрын
Thanks for coming by!
@jameslaird5303
4 ай бұрын
I have a recently acquired M1-Garand (4225532) 1952 - 1955. Was not properly cared for by the previous owner. Safety did not work because the trigger group wasn't installed properly, rear sights were messed up mainly from over-tightening, the sling was white and much too long (it wasn't installed on the front sling clip but on the stacking swivel). I have not fired it yet because I need to have the gas plug removed before I will feel confident in firing it. It has what appears to be a set screw to prevent the gas plug from being removed. If it is a set screw it is near the base threads of the gas plug. Both have been damaged from attempted removal. I have never seen any other Garand with this apparent set screw. Anyone else? I will be taking it to a gunsmith shop in a couple of weeks for a good checkup.
@cornfromajar3222
3 ай бұрын
I can only make assumptions without seeing the gun in person, but it’s a good bet that yours was used by an honor guard at some point (American Legion, VFW) for ceremonies or funerals. I’ve had some experience around those groups and those weapons can live a rough life. Again just a guess without me seeing the weapons in person. Thanks for coming by!
@jameslaird5303
3 ай бұрын
@@cornfromajar3222 -- turns out that it was no set screw. It was welded to make it totally inoperable. The weld went through the gas cylinder, the screw, and the lock. And there was a very fine (thin) cut through the sight and down the the gas passage to the gas cylinder.
Пікірлер: 76