Hello sir , I would like to know if i can use my old mpg db25 lpt in the same time using the working usb xhc board , can't make it work with the info i find on the internet. please help ! thank you best regards Fred
@jofeljamili355
2 жыл бұрын
HI! I had problem setting up my mach3 usb .. why output1 no voltage reading
@NaF_Art_Studio
3 жыл бұрын
Hello, i set up my machine but when asked to cut a 10*10 cm swuare it cuts it at 7*7 .. what might be wrong n of anything u'd recommend
@andirachmatmulya2818
3 жыл бұрын
Dear Friend, I trying to make conection for limit switch using two Normaly Close switch with serial conection and put enabled check mark on X axis on Mach3, after push apply and OK botton, limit switch does not active (LED input signal does not light up) eventhough I hit the switch. Whats wrong?
@mikefromspace
Жыл бұрын
I don't get it. My active lows are checked green, yet led's light up. Mine's backwards from this. Why? (also I still haven't been able to turn a servo) I see he's making money off the video with ads but nobody gets questions answered here! great
@Julie0374
4 жыл бұрын
Thank you.
@khanjee8448
3 жыл бұрын
can we save X and Y axis permanently
@carlosvallori2365
3 жыл бұрын
i have an error Plugin DLL Defective. Reoaded. Can you helpp me? is Paralled Port
Пікірлер: 11