Thank You for watching! Please consider subscribing to our channel and clicking the bell icon to receive future updates.
@89unica
3 жыл бұрын
We own a 1635 shuttle and have been very pleased with our purchase. My only complaint is the location of the fuel fill, but that is a small item relative to its over all value. For attachments we have the 5' brush cutter, front end grapple, snow plow and 5' box grader, all have the Mahindra brand on them and again, very happy with all of them. the only add we did over what came standard was the third function hydraulic control on the loader lever.We have owned the tractor for the past three years.
@LedgemereHeritageFarm
3 жыл бұрын
I agree about the fuel fill. My cub cadet had it behind the seat . I ended up buying a bulk tank for fuel. Thank You for watching 😊
@samhotstick13.28
2 жыл бұрын
First time tractor buyer, thank you on the information, you may have made up my mind. This same tract🇺🇬
@LedgemereHeritageFarm
2 жыл бұрын
I’m glad I could help. Best wishes, Tom
@perry9492
3 жыл бұрын
I am on the fence on Mahindra right now. Having trouble getting a loader for my 3016. They have it but can't find all the parts to install it. Glad you found a good dealer.
@LedgemereHeritageFarm
3 жыл бұрын
Ugg. I sure hope they can come through for you.
@LedgemereHeritageFarm
3 жыл бұрын
Thank You for watching!
@Speido307
2 жыл бұрын
I agree, first impressions make a big difference, thanks for sharing.
@LedgemereHeritageFarm
2 жыл бұрын
Thank You for watching
@hartiaacres
3 жыл бұрын
I went to several dealers before going to Mahindra. I ended up with a 1635HST TLB. Have over 200hrs on it now. Not as powerful as I expected. But it,s saved me a ton of money. I have a few hates with it. The seat set-up for using the Backhoe. That needs some re-thinking. Very awkward to use IMO. Throttle is in a bad spot. Catch my pants or boot on it. Same deal with the turn signals , always catching something on that as well. No regrets on the purchase so far. Wish I added the 3rd function control . And a grapple bucket for the front. Snow plow blade and rear blade will be next. Oh if you source a non factory engine filter pass it along. Manual states factory oil filter .But has a list of others for for the hydraulics and such.
@LedgemereHeritageFarm
3 жыл бұрын
I’m always catching the the turn signals too. I’ve been super careful, but that pile of hydraulic hoses under the right floor pan is asking for trouble. Thank you for watching
@hartiaacres
3 жыл бұрын
@@LedgemereHeritageFarm Ya it,s a mess , especially when running the backhoe. I have 4 or 5 rubber bungees strapping hoses in place. I actually unplugged the Hoe arm on a stump. Ground clearance is limited in the rear with the Hoe as well. Been stuck several times over rough terrain. I use mine as a bush tractor. Currently clearing land for our house build.
@LedgemereHeritageFarm
3 жыл бұрын
@@hartiaacres ugggg
@Formerlywarmer
3 жыл бұрын
What was the cost of the 1635 ?
@LedgemereHeritageFarm
3 жыл бұрын
Loaded tires, 60” Bush hog, front loader, bucket hook, block heater, $23,551.
@reneprovencher8395
3 жыл бұрын
I like that you showed the different parts on the Mahindra. Makes a difference if I purchased again. I'd never buy kubota again. Because my seat does not have armrests. I don't have shoulder rotators so armrests now would be a must.
@LedgemereHeritageFarm
3 жыл бұрын
Thank You for watching Rene. I think the newer deluxe Kubota tractors have ram rests, but they’re too pricey for my blood!
@LedgemereHeritageFarm
3 жыл бұрын
Thank You for watching!
@Gwalker0220
2 жыл бұрын
Well after a couple years you will notice oil leaks and bent tie rods, blown lines... It will never last half as long as a kubota and the warrenty dont mean a thing they never honor it... Sorry but mahindra is built by whoever they can get to build it the cheepest...
@LedgemereHeritageFarm
2 жыл бұрын
I guess time will tell. I’ve seen plenty of bent tie rods on kubotas because they put them in front of the axle rather than behind. Mitsubishi has always made good tractors and they all get their little parts and pieces from the same suppliers
@LedgemereHeritageFarm
Жыл бұрын
3 years and it’s still going strong. It’s been a good tractor and I just mowed 14 acres of hay with it today
@mattkatemaybee1979
Жыл бұрын
@@LedgemereHeritageFarmhi. Really considering the 1635 primarily for cutting 20 acres or so. How big of a mower do you have on yours?
@LedgemereHeritageFarm
Жыл бұрын
@@mattkatemaybee1979 I use a 5’ bush hog and a 6’ 6” sickle bar mower
Пікірлер: 24