Thanks for the advice. Great video ... simple, short and to the point. Well done !
@CHIBA280CRV
Жыл бұрын
Sir thanks, this was a very informative video , sure helped me a lot ..🙏👍🏼👍🏼👍🏼👍🏼👍🏼
@karlmawby2921
3 жыл бұрын
Blows my mind how far it's ce since the bubble balancer I started out on....
@user-uo9kq4sk2c
10 ай бұрын
If you calibrate in dynamic mode, will the calibration for ALU-S be accurate? Or do you need to run a calibration in ALU-S mode?
@nathanmciver6496
2 жыл бұрын
Lol! Awesome! If I didn't like the video, it was because of the machine! Great explanation! I found another machine that seemed like the interface looked alot easier to navigate! You have to be there and it should be what the persons preferance is!
@Mrdubomb
4 жыл бұрын
Im almost always out 1/4 to half on the first spin, guaranteed, brand new machine, what am I doing wrong?
@mattzhang5348
4 жыл бұрын
call Jim for a tech support, or i can get Jim to call you.
@mattzhang5348
4 жыл бұрын
what is your phone number?
@jimromani3670
4 жыл бұрын
Hi first make sure machine is calibrated well you should get 0.00's most of the time in one spin, in dynamic mode hammer weights. If you are only getting the .25-.50 in Alum-S mode then your measurements are off. I recommend a fabric tape measure from the dollar store and enter your wheel inside diameters into the machine before mounting on the machine. The diameters go in .1 increments. If you just roughly guess the diameter this will cause .25-.50 to show a second time.
@Mrdubomb
4 жыл бұрын
You are correct, it is only in alu-s mode Ill try what you suggest
@Mrdubomb
4 жыл бұрын
generally when I am alu-s mode I am using clip on for the inside, should that measurement be whatever the tire diameter is?
@ujash2003
2 жыл бұрын
Garbage machine not a flat rate machine, have to measure everything manually
@tirechangerca
2 жыл бұрын
Hi Kumar, how much you bought this machine? we have automatic one.
@user-uo9kq4sk2c
10 ай бұрын
If you calibrate in dynamic mode, will the calibration for ALU-S be accurate? Or do you need to run a calibration in ALU-S mode?
@tirechangerca
10 ай бұрын
calibrate it in dynamic will work for all modes including ALU-S.
Пікірлер: 16