How is it that when you create a circular pattern they form around the original surface? I've been trying for ages and I can't get it to allign because it creates 4 faces that are a distance away from each other
@Catboy-hr2qp
Жыл бұрын
What cement you using? I was thinking of trying plaster of paris mixed with fine sand
@MarCeeVin
2 жыл бұрын
what kind of filament did you use for the soft/ flexible 3D Print?
@makerlifeon3981
2 жыл бұрын
I used TPU filament for flexible prints
@DevArt59
10 ай бұрын
Would you make a full walkthrough video ?
@fernandoalava371
Жыл бұрын
how did you print the mould?
@cipetonk
2 жыл бұрын
Helo, after using oil as lubricant, can you paint the concrete with water based paint and water based concrete stain?
@makerlifeon3981
2 жыл бұрын
Paint may not stick, sanding may help,
@garluis23
3 жыл бұрын
what type of lubricant are you using?
@makerlifeon3981
3 жыл бұрын
Any oil will work
@sarasoorah
3 жыл бұрын
Nice work! small question: How are you able to move sketch to different planes and sketch on the 3 of them at the same time? as I'm trying to follow your way but it's not working.. thanks!
@makerlifeon3981
3 жыл бұрын
You have to remove all the constrains, all the lines should be in blue, and make sure 3D sketching is activated
@yarencelik7800
2 ай бұрын
@@makerlifeon3981 thanks
@actualizator
3 жыл бұрын
Hello. Great work! One question. Is it pure concrete? Or did you mix it with sand?
@sreenathable
3 жыл бұрын
I used pure concrete, it cracked afterwards. Better to mix sand to avoid cracking
@umbeatable2770
2 жыл бұрын
@@sreenathable can i do the same with cardcoard paper ?
Пікірлер: 23