This is going to wear down the wheels pretty quick!
@IExSet
8 жыл бұрын
Dangerous design !
@nikkomartin9915
3 жыл бұрын
If you turn skateboard the deck are moving impossible not to hit the break
@ericstagg6580
10 жыл бұрын
you can get aluminum and steel round rod at most hardware stores.
@adam_-adam
9 жыл бұрын
yea well good concept" try bending that bar that you facing foward of your board where you step on and have it go through those little brackets and thanface it rearward and than have it bend down towards the ground behind the board and than install some rollerskate brakes, like those big rubber round corks or whatever, than when you step on the metal bars that are facing backward it will put pressure and skid on the ground behind your board
@kssna81
5 жыл бұрын
cool
@lucaslopez4136
9 жыл бұрын
what if you press it to hard and it goes over the wheel your going leave your nose on the floor
@clinton7360
5 жыл бұрын
did you ever find a material to go on it?
@adam_-adam
9 жыл бұрын
that aluminum bar is not going to hold up which you probably found out after making this video, should have used steel as aluminum will probably bend after only a few times of stepping on it
@marccawood
9 жыл бұрын
+Adam Renwald Yep, and I thought it would. Problem is I don't have such steel nor could I bend it and temper it properly to prevent deformation. Was more of a proof of concept and I've seen other similar designs work.
Пікірлер: 12