I would spread the intake / exhaust far apart having exhaust at higher side of window. To avoid circulating back into intake. Heat naturally goes upward, cool air stays at lower side. It done right efficiency of these portable. Accommodate with descent size fan to reduce the power needed to run the AC
@aarondcmedia9585
Ай бұрын
Your process is methodical and makes for a good fit. Thank you for sharing.
@chrislusk2189
29 күн бұрын
Thank you
@Fourax
29 күн бұрын
Why did you put the intake outside ??? put it inside ! You're taking hot air from the outside to cooldown your car, if you put it inside, you're gonna take the "cold" air to cooldown the inside, it's gona work betther !
@chrislusk2189
28 күн бұрын
I was just going by what the instructions are telling me to do but you make a good point and I will try that out. Thank you.
@diex101
28 күн бұрын
Then you’re venting the cool air and pulling hot air in. That defeats the entire purpose
@F_GDiary
6 күн бұрын
Nice… very helpful!
@annwithaplan9766
27 күн бұрын
Good job. I saw them being sold online, but they're WAY too expensive. I have the same Ecoflow unit, but I use mine in my bedroom because I didn't want an a/c in the window. I used a piece of styrofoam and only put one hole in it for the heat exhaust tube. No sense in pulling hot air in if I don't have to.
@chrislusk2189
27 күн бұрын
Yes, I seen a few comments where they’re only using one of the holes for the exhaust. I am going to make another one I wanna try that out and see the what kind of difference it makes.
@aspeler22
29 күн бұрын
I shot mine through the moon roof with supports like yours with some foam board insulation to keep the cool in and heat out. Additionally, it's not as easy to break in or to be as noticeable to others, even when I'm not there. It's also out of the way of the front seat. It's on the console and there is also less conduit going in/out so as not to heat the 4Runner when using my EchoFlow Wave 2.
@sidneyking11
Ай бұрын
I was thinking what if it rains? maybe you can add a dryer vent adapter that has a flap built in it and a cover. Add it on the end of the hose that exits the window. Just a thought.
@chrislusk2189
29 күн бұрын
I have an awning that comes out and it covers it. But yes, that would work also.
Пікірлер: 12