This is the 3rd video in the series of “Make your own Arduino Uno”.
In the 1st video, we have shown you how to make an UNO on a breadboard and in the previous one we converted that breadboard version to a permanent PCB.
1st video: • Make your own ARDUINO ...
2nd video: • Make your own ARDUINO ...
In both cases, the blink sketch was working perfectly. So if you haven’t watched those videos, click here because obviously, it will be easy for you to understand.
So in this part 3, we will be programming the Arduino IC aka Atmega328P using USBASP. By this method, we don’t need to remove the IC from the IC base, just hook up some wires in power and control pins and we will program the IC.
-----------------------------------------------------------------------------------------------------------
Link for the drivers to be installed: netmaxtech.com...
Link for AVRDUDE: drive.google.c...
-----------------------------------------------------------------------------------------------------------
Facebook Page: / being.engineers.1
Follow us on Twitter: / being_engineers
Follow us on Instagram: / engineers.being
Google+: plus.google.co...
Check out our Instructable corner: www.instructabl...
Visit our site - www.being-engineers.com
Негізгі бет Make your own ARDUINO UNO - Part 3
Пікірлер: 2