Watch the short version here: • Making a 9 Color Sign ...
Making a 9 color sign for my daughter's room using Amana Tool® CNC Router Bits and STEPCRAFT M.700 CNC machine available on our website. www.toolstoday.com
Matt from ToolsToday used the 90° V-Groove insert carbide router bit no. RC-45711 to make very clean cuts through the Oramask 813 into the wood. The bit carves through the mask perfectly leaving no cleanup work, especially with the cleanup pass built into the @vectricltd software. Oramask 813 was applied to the piece before it was carved each time. Painted with General Finishes Sunglow Milk Paint, it dries quickly and limits any bleeding. Finished with Helmsman Sparurethane. ToolsToday provided product.
Feed, Speed, Chip Load & Step Down CNC Running Parameters
Amana Tool In-Tech™ Series Insert Carbide V Groove 90 Deg x 11/16 D x 1/4 Inch SHK Single Flute Router Bit no. RC-45711
RPM: 18,000
Feed Rate: 35ipm
Plunge Rate: 17.5ipm
Max Depth of Cut: 0.25"
www.toolstoday...
Oracal ORAMASK 813 Stencil Film 12 Inch Wide x 20 Foot Long Roll
www.toolstoday...
General Finishes Milk Paints and Stains
tinyurl.com/pa...
STEPCRAFT M.700 28" x 36" CNC Machine
tinyurl.com/st...
** Subscribe - / toolstoday
** Shop the website - www.toolstoday.com
** Like at Facebook - tinyurl.com/too...
** Follow on Instagram - / toolstoday
** STEPCRAFT Machines - www.toolstoday...
Негізгі бет Making a 9 Color Sign | ToolsToday
Пікірлер: 39