Tim here. Thank you Mr. Mike and Phil for the RAPID response to my questions AGAIN. Going to work on making the right size needles now. I have this episode saved also. GREAT WORK!!!
@mikeusina73
5 ай бұрын
Tim, I'm sending you a needle.
@jamesb1307
4 ай бұрын
Hey Mike, would It be possible to buy a needle from you.
@mikeusina73
4 ай бұрын
@@jamesb1307Where are you?
@jamesb1307
4 ай бұрын
I am in South East Georgia.@@mikeusina73
@louisoyugi837
5 ай бұрын
I have got my net about one foot in length and with great luck got the wideners all neatly in line. My wideners are now 5 meshes apart. I am doing the met with a 3/4 of an inch with an extra cm gauge. Following your invaluable advice I will get to a point of making my met. Thanks
@mikeusina73
5 ай бұрын
Sounds good, keep up the good work.
@louisoyugi837
5 ай бұрын
I will get into watching the ones where there are wideneners
@louisoyugi837
5 ай бұрын
Hey, Mike and Phil. I am now at my seventh plain row and was it knots I could not tie or untie... How to tie the first 41 meshes was hard. I almost had 6 meshes and so much tied up together one after the other. I made expanders as well as meshes together on the 1st row.
@louisoyugi837
5 ай бұрын
I almost had 6 meshes and so much wideners tied up together on the first row. I think you got it right when you got to say as an experience that could happen at the first row... I love you all. And Phil your camera shots works great it does wonders.
@godkingcthulhu138
5 ай бұрын
🐙
@louisoyugi837
5 ай бұрын
Hello, I have gone over my seventh plain mesh row. I made a count of the wideners going about the first widener row. If I made a count through that eigth row of the wideners that would be and I was getting 13 wideners finishing with 3 plain meshes. Now does each widener row after the first 13 wideners row be started with one mesh and a widener after that?
@christophersmartt6013
5 ай бұрын
What is the dimensions and weight of your cast net sinkers?
Пікірлер: 16