Project concluded, but might still need to make adjustments to the fork edges by filing them a small amount to prevent scraping. It sounds a bit different than I expected, but still better than no sound. Definitely easier to downshift into 2nd and to get into first now.
If you are planning on recreating this setup, the templates for the supporting structure should be used as-is to ensure the height of the plate is correct. the plate itself will have a large offset for the gate depth if you didn't modify the shifter cable position as I did in Part 1. You will want to sand the raised edge on the shift rod flush so that it slides into the forks smoothly. For the Cover, you will want to modify the position of the plate relative to the base (back right corner is too high) and then shape the rails to give you a smooth loft.
drive.google.com/drive/folder...
00:00 Comparison demonstration
00:45 Figuring support structure
02:00 Installing support structure
03:00 Making the shifter plate
04:45 Finalizing the cover
05:35 Driving footage
Негізгі бет Автокөліктер мен көлік құралдары Making a Custom Gated Shifter for my MR2 Spyder, Part 2
Пікірлер: 10