I have a feeling you are cleverer than you let on !!!
@robertoswalt319
5 жыл бұрын
Nicely done. I look forward to watching you remove the change gears from that plate stock.
@ronaldcrowder404
3 жыл бұрын
Amazing job . I have an atlas 618 with no half nut or Carriage advance and rack and have a broken 16/32 gear combo so now I now I have a big challenge ahead of me . I will be modifying the apron and making gears and half nuts and hope I can come close to the job you have done !!
@clutch5sp989
Жыл бұрын
Great shtuff...right now, these parts are $85 on Eqay. Eliminate snakes & crooks who will price gouge the ones who are ripe for the taking.
@johnstrange6799
5 жыл бұрын
Thanks.
@davidhofman4341
2 жыл бұрын
I printed change gears for my 109 witch will also fit my 618.
@dannywilsher4165
4 жыл бұрын
Nice job sir!!!
@YOURFISHINGCHANNEL
4 жыл бұрын
i watched the 2 films , looks very time consuming but very fulfilling
@Just1GuyMetalworks
5 жыл бұрын
Nice Job! Better than he original for sure 👍😁👍.
@kikogarza6310
2 жыл бұрын
Good video gracias
@geraldedwards1577
Жыл бұрын
Hoping do that to my Boxford model A which has worn out half nuts and cannot buy knew ones
@mikelopez6269
3 жыл бұрын
Bravisimo
@KentRigby
Жыл бұрын
Could you make me a half nut and bracket for the 618? I have two sets of half nuts and both are worn out. The half nuts are unobtainium and I have zero skills millimg and machining. I would, of course, pay you for the parts.
@johngturner
Жыл бұрын
@TheBuildist UnObtainium is found in pandora I believe. Lol good luck getting some of that!
@steelcappedstrength
5 жыл бұрын
How were you able to gauge your 16 tpi acme cutting tool? My little acme "fishtail" gauge ends with 10 tpi. Thanks!
@TheBuildist
5 жыл бұрын
I don't remember for certain. I think that I probably set my grinding guide to grind the hss blank at a 29 degree angle, and then ground it close to a point. Then ground it back square until it fit snugly in between the threads on my 16tpi lead screw.
Пікірлер: 16