Thank you for taking the time to go through your whole process. Very instructive for a beginner to scroll sawing. Cheers!
@jahellen
Жыл бұрын
Glad it was helpful!
@badmandansanchez1823
3 жыл бұрын
Solution to your pilot hole dilemma.... Drill the hole in the part of the drawer that gets cut out and thrown away. Thought of that half way through my current box, sure it will work though. The pattern you used in this video was the same I used for my first bandsaw box I made the pulls look like an emoji face😊
@MrPaulRobbins99
3 жыл бұрын
Bugger just read this, would have worked really well
@biodieseler1
2 жыл бұрын
It took me 12 minutes before I noticed your T-shirt. Perhaps the title could have been Critical Scroll... ? ;0)
@shelbygiordano8504
4 жыл бұрын
thank you so much i have learned a lot..
@jahellen
4 жыл бұрын
Glad to hear that
@tinabillmam4896
5 жыл бұрын
Sand less and gaps would be better. Stack cutting
@arowe231
4 жыл бұрын
What size Dewalt clamps are those that you are using? Nice job on the box.
@jahellen
4 жыл бұрын
Fairly small ones, but not the little tiny ones. 6 or 8 inch, I think.
@sabrinaphilibert4622
3 жыл бұрын
Where can I have the pattern of this box ??
@jahellen
3 жыл бұрын
I used a pattern I found in 'Box-Making Projects for the Scroll Saw' by Gary MacKay.
@sebastianfajardo4602
6 жыл бұрын
Great looking box! What type of double sided glue did you use?
@jahellen
6 жыл бұрын
I'm not sure exactly what you're asking. I used regular yellow wood glue throughout the entire project (although for something like this white glue would probably work well, also). I put blue painter's tape on the wood then use a glue stick to attach the scroll pattern to the tape. (The tape helps lubricate the scroll saw blade and allows for cleaner cuts.) I use thin double-side tape with a peel-off backing to attach multiple layers of wood together if I need to scroll them at the same time. Hope that helped.
@oldman719
6 жыл бұрын
Why did you use a size 2 blade for the inside and a 9 for the outside on the same thickness wood?
@jahellen
6 жыл бұрын
I used the size 2 blade on the inside to minimize the size of the hole I had to drill into the work piece. I used the number 9 blade on the outside hoping it would make cutting through the thicker wood easier, but I didn't notice much difference, and, if I were doing it again, would probably go with a number 7 or even leave in the number 2 and go very slowly.
@johnjordan2171
6 жыл бұрын
how long from start to finish would this project take nice work
@jahellen
6 жыл бұрын
Thank you! I don't remember exactly how long this took, but based on the video I'm guessing it was a day's work, although a significant amount of that time was spent waiting for glue to dry. You could easily knock this out in a weekend.
Пікірлер: 20