Making Leather Hat Patches on a Laser
In this video I go over the process of designing leather hat patches in Lightburn and then producing the product on my OMtech Co2 laser.
Leatherette with adhesive backing from JDS Industries
100w OMTech Laser
Engraving
500mm/s at 20% power .1 line interval
Cut
50mm/s at 40% power
Lightburn Course
Course.beardedbuildsco.com/store
Fuel and support me!
www.buymeacoffee.com/beardedb...
I have many of the supplies that I use listed in Amazon affiliate store:
Amazon.com/shop/beardedbuildsco
OMTech Lasers:
omtechlaser.com/LSG
Affiliate code “BEARDEDBUILDS”
Coupon code “BEARDEDBUILDS5OFF”
OMTech Laser Facebook Group:
facebook.com/groups/13640...
Socials:
Instagram.com/beardedbuildsco
Facebook.com/beardedbuildsco
Негізгі бет Making Leather Hat Patches on a Laser Using Lightburn
Пікірлер: 54