Good video can’t wait to get a couple templates made up
@publicoutlaw1731
10 ай бұрын
Love it
@andywoessner2604
10 ай бұрын
The dead milkman haven't heard them in years...
@alanraven7539
10 ай бұрын
good vid mate..... really helpfull
@axsomoutdooradventures
10 ай бұрын
Thanks so much.
@SurvivingThisCruelWorld
10 ай бұрын
I'm still using the band ruler. I found a taper I like, but I want to try out some more before investing in a template. I got my band set making down to a routine where everything is measured, counted, wrapped, and tied the same way every time. Trying to eliminate some of the variables lol/
@sawemshotem
5 ай бұрын
Set it up diagonally. That helps me reach all the way over. I also focus on holding down the strip I am cutting not the whole board.
@wills400
10 ай бұрын
File ur cutter down so the blade goes through the acrylic more or upgrade to 60mm cutter
@burdisdead
7 ай бұрын
I always heard you dont want to press to hard cause it has the rubber squishing but you already have it pressed down hard with the template
@joshuasmith2107
3 ай бұрын
So I shoot 8mm and have been getting the pre-made bands from simple shot but have been wanting to make my own and buy the latex in bulk. What taper do you recommend with that size ammo? And should I take my size of latex down from .7 to .6 mm ?
@axsomoutdooradventures
2 ай бұрын
I shoot 8mm, and I usually shoot .4 or .5. I used to shoot .6 often, but I found that I like it better with 9.5mm. I would try .5 and get a taper ruler so you can adjust and experiment with different tapers. Half of the fun is experimenting.
@joshuasmith2107
2 ай бұрын
Thank you, I appreciate your feed back and will certainly give it a try. Love your videos, very educational, keep them coming
Пікірлер: 13