What is the best way to know your batteries are healthy. Or just being taken care of.
@philscott9405
2 жыл бұрын
was the wire to the cut out at the trolling motor connect panel pre wire from mako? or did they run that after you purchased? just wondering if i cut my panel location open, am I going to find wiring in there? but I guess if i dont see any wire coming through the anchor box area, ...no wire, correct?
@reelfunfishingofswfl6892
2 жыл бұрын
Mine was cut out with wires already ran with switch and breaker built in. Thank you for your comment. Please like and subscribe.
@angelberrios7843
2 жыл бұрын
Wondering how you installed that trolling motor locking device and the name of it.
@reelfunfishingofswfl6892
2 жыл бұрын
Its the minn kota quick release plate.
@AmazonWebService98
2 жыл бұрын
@@reelfunfishingofswfl6892 can u tell me what the tag says on the back of the plastic cover where you plug in the trolling motor , i'm trying to find that. Also how does the wire run from that plug to the battery is there's another hole that needs to be cut ?
@reelfunfishingofswfl6892
2 жыл бұрын
@@AmazonWebService98 my wires were already ran by mako. Thank you.
@JustinCaddell-fv8tz
Жыл бұрын
What’s gauge cable did u use to connect battery to battery
@reelfunfishingofswfl6892
Жыл бұрын
I just used the size that was on trolling motor. But always use marine cable and Croczee heat shrink with glue inside. Thank you for your comment. Please like and subscribe.
Пікірлер: 19