Just got one the other day at Lowes-Has a Honda Eng. Kicks butt.
@paulclemons705
10 жыл бұрын
Excellent video - thanks !
@knucklebuster61
13 жыл бұрын
Rebuilding an old one of these and found this video very informative; Although I had to adapt it to the old model. Mine actually has a grease Zirk on it.
@MrsBuddevil
3 жыл бұрын
What's a grease zirk
@glennfarrar3107
Жыл бұрын
Need a ign coil for a model SV4B, any ideas on where to find one? Or would a short laer model engine fit?
@ArticleTen
13 жыл бұрын
Do you have a video showing how to rebuild the carberator?
@ikeboy
11 жыл бұрын
Excellent. Big thanks!!
@roddyb
11 жыл бұрын
This was useful
@djwriterlaroche1617
7 жыл бұрын
i have a ? How Do I unseize My mantis 2 cycle garden cultivator/tillers engine
@crazywilliemullins4050
6 жыл бұрын
Did ya find a fix for 4 cycle times not turning
@donjuwann5868
3 жыл бұрын
my Honda 4 stroke is blowing oil out the carb?
@frankashby6235
3 жыл бұрын
I cant seem to get the carb adjusted correctly. The Mantis Starts fine and doesn't seem to have a problem with acceleration. However, it wont idle for more than a minute without shutting down. Any suggestions??
@glenzabriskie3952
3 жыл бұрын
Possibly bad gas or fuel filter?
@razakabubakar3677
5 жыл бұрын
My tiller wheel is not turning .pls the cause
@GregJoshuaW
11 жыл бұрын
no joke - me too.
@theresahinson9609
7 жыл бұрын
I have a 4 cycle tiller/cultivator and cannot get the tines to turn, what should I do?
@crazywilliemullins4050
6 жыл бұрын
Theresa Hinson I have the same problem
@johnmaher7849
6 жыл бұрын
The tines on mine stop turning as soon as it's put to work. I have checked everything but no sing of wear😣
Пікірлер: 22