Wheel-tool, change your own tire from rim.
10-10-2013 After balancing with dynabeads with several wheels over time, no good results, can't advise it.
Also lateral unbalance can't be fixed with the beads.
Woble repair from steel wheel (rim):
- Measure the lateral runout at the rim where tire is mounted and mark this place.
- When inside and outside are at the same spot, it can be fixed
- If this is 2mm, then you can grind with angle-grinder about .8mm on the side marked from the surface where the rim is mounted to the verhicle.
- You should be very experienced with the angle_grinder, as the surface must be plane ofcourse.
- When mounting the tire: pump it with air till max. what's written on the tire (is important), put the valve and reduce till what you normal drive with.
I was able to reduce the wobble with 50% measured at a steel rim. Measured at the mounted tire later, it was reduced about 70%.
No more vibrations at 100-120km/h, as this is what lateral runout does.
• Video
Негізгі бет Manual Wheel / Tyre changer tool DIY old school
Пікірлер: 50