What kind of material is that? The stepover and helical ramping seems very low.
@AlberttoMezza
6 жыл бұрын
which coating has vertical milling?
@ywaran431
3 жыл бұрын
How much is the RPM ,feedrate, step-down and stopover for this operation?
@stanislavtimanov
5 жыл бұрын
wHAT IS SPEED OF THIS VIDEO?
@metzenw86
7 жыл бұрын
SFM is way to high and your step over is WAY too low. Your helical ramping took 1 Minute and 14 seconds. A 5/8 HSS Drill running at 100 sfm at 4.5ipm would drill that starting hole in 15 seconds plus 6 seconds for a tool change, saving you about 50 seconds. And that is conservative for a drill. Chip thinning works to a point. If you cut your step over in half and double your feed rate. It's still the same removal rate.
@ipadize
6 жыл бұрын
could be hardened material
@AsitShouldBe
3 жыл бұрын
so you make an hole on the vice.. lol
@MotorsportsX
6 жыл бұрын
Cut climb and coventional. Lots of time savings
@zuhalfast3388
6 жыл бұрын
25 minutes for a pocket?? 🤷🏻♂️ I guess it’s chromolly?
Пікірлер: 13