i just realized that i didn't program turning ops for a long time using mastercam, now we have only mazak turning machines and is so fast do it on the control i did enjoy programming lathes...
@TheColors90
Жыл бұрын
Is there a simple way to start your turning on the id where your clearance drill leaves off? By starting to bore at x0. The bottom of the bar crashes on the opposite side it’s supposed to cut.
@robincoope5352
3 жыл бұрын
With MasterCAM you are always 95% there but you are totally stuck, so you turn on KZitem, and in my case, you see you have to turn on stock recognition. Obviously! (in retrospect) Thanks for this and the other useful points you make here.
@mooraymachine5019
3 жыл бұрын
Hi Robin. Sorry for the delay in response. I thank you very much for your kind feedback. If there is anything else I could assist with, please let me know. I feel as though my videos could all use an update, but I would prefer to have the audience decide what could use better explanation.
Пікірлер: 5