I had a Mauser 98 with the same problem. NEVER file down the mounting tabs that hold the bolt catch. Someone must have filed them down at one time to compensate for a sloppy fitting bolt catch only to make it an even sloppier fit. The only way I can see to fix this is to build up the metal with a welder and file it back down to the correct profile and tolerance. Measure the correct tolerance on one of your good rifles to use as a model to get the correct tolerances. Good luck.
@RUSTYSURPLUS
2 жыл бұрын
Hey Spark.. looks like you need 2 little 1 /8 th spacers on top of the mounting tabs try that let me know. I have never seen that before.. some wacko with a file geeze.
@billjenkins687
6 жыл бұрын
Shit. Did you find a precision welder to add material? It is certainly possible.
@reneruscheweyh6408
5 жыл бұрын
Do you know if there is any way of getting one of these? My gun is missing it
@Sparkfly88
5 жыл бұрын
If you are in the USA, try gunpartscorp
@tewdogs4475
4 жыл бұрын
e-bay has them
@essanta
10 жыл бұрын
That is your bolt catch not the ejector. The ejector is the long rod on the opposite side of the bolt catch. The difference that you spotted in the two may be the issue. I would also look at the spring to see if it is worn too much. Did you try the k98 bolt catch on the other mauser?
@albirasistendragen
4 жыл бұрын
BUBBA'D.COM
@liamh9064
3 жыл бұрын
I guess going off this example German conscripts weren't great at repairing/maintaining the ejector mechanism and in fact had no idea what they were doing
Пікірлер: 9