It's great to see you again on your channel. As usual, your work is of high quality.
@rotaryperfection
Жыл бұрын
Nickle rod huh!!! Thx for sharing that info. My 20b had the same issues back in 2010 on my thick center plate so I just used a mig welder back then. I think it's slightly leaking so I may grind the repair off and go with the nickel this time around.
@sgoldens24
Жыл бұрын
Very impressive workmanship sir !
@eddysmit
2 ай бұрын
Can you be a more precise about the nickel rod? Is it Tig welded?
@mazcatii
Жыл бұрын
Good to see you back uploading again mate, how's the little shop rat Cleo doing?
@josephruiz3949
Жыл бұрын
I’m currently doing this to an engine I disassembled what are you using to shape them??
Пікірлер: 6