How good is this blade? I think this may be the measuring stick for how to heat treat MagnaCut. Why? I got the answer directly from Jon McNees.
Disclaimer: this video is for entertainment purposes only! Do not attempt any of the tests you see in this video because they may lead to severe damage to any knife, loss of warranty, and possibly to a major injury.
Dr. Larrin Thomas Knife Engineering book👍👍👍❤️
amzn.to/3ufYDVF
Tsubosan hardness test file set: 👍👍❤️
amzn.to/48EBICF
My most used screwdriver Set by Hoto 👍👍❤️
amzn.to/3vGJ6ip
Torx T6 bits for a 1/4” drive 👍👍
amzn.to/47rqQaV
Негізгі бет McNees Mac-2-3.5 tested, analyzed, and explained.
Пікірлер: 80