How to measuring light brightness, using a photocell sensor, a Micro:Bit, and the Sensor Shield V2.
1. A simpler version of this project (using the on-board light sensor) can be found here:
makecode.micro...
2. Full details of the 37 in 1 Starter Kit, as well as the project description and a schematic diagram can be found at the link below:
wiki.keyestudi...
The specific project is "7.22 Project 22: Light Brightness".
3. You can purchase the 37 in 1 starter kit here:
www.keyestudio...
You may want to watch these videos too:
Programming an LED to 'breathe' with micro bit and the Keyestudio Sensor Shield: • Programming an LED to ...
Programming a Digital Buzzer with micro:bit and the Keyestudio Sensor Shield: • Programming a Digital ...
Programming an LED to flash with micro:bit and the Keyestudio Sensor Shield:
• Programming an LED to ...
Programming a RGB LED to flash different colours on loop using the Keyestudio Sensor Shield:
• Programming a Passive ...
Using a Capacitive Touch Sensor with your Micro:Bit
• Using a Capacitive Tou...
Using a PIR Sensor with your Micro:bit with the Keyestudio Sensor Shield V2
• Using a PIR Sensor wit...
Using a Flame Sensor with a Micro:Bit and the Keyestudio Sensor Shield V2.
• Using a Flame Sensor w...
Using a Crash Sensor with a Micro:Bit and the Keyestudio Sensor Shield V2.
• Using a Crash Sensor w...
Using a Relay with a Micro:Bit and the Keyestudio Sensor Shield V2.
• Using a Relay with a M...
Негізгі бет Measuring Light Brightness with Micro:Bit and the Keyestudio Sensor Shield.
Пікірлер