Very nice and useful. Kindly make video on track roller carrier roller ,Idealer also.
@michaelscafe2818
Ай бұрын
Where do you find the track wear charts? Im looking at a 450c with an easy 25.5 inches. Wondering what percentage that would be
@JimMackHeavyEquipment
Ай бұрын
You would find that from the OEM. John Deere makes an "Undercarriage Appraisal Manual (sp326vol1)" and in there for a 450c it lists the new track chain pitch as 25.19" and 100% worn would be 25.67". Unfortunately I don't know any where you can get this manual for free. I hope that helps!
@JimMackHeavyEquipment
Ай бұрын
@@michaelscafe2818 oh, and your measurement of 25.5" would be considered about 65% worn.
@michaelscafe2818
Ай бұрын
@@JimMackHeavyEquipment that helps greatly. Thank you. I might have closer to 25.67 if I stretched the track as you showed. I wasn't able to move the machine, so I just measured it as it sat. Worst case is I buy the machine from my friend and turn the pins/bushings and probably replace some rollers. As far as sprockets, is an 1/8 to 3/16 inch flat on the crest of the tooth worn too sharp, or is that still serviceable?
Пікірлер: 5