Hi Joseph, Great video, when I change brake pads I pry the cylinders back with a large ring spanner, rather than a screwdriver/prybar Regards Phil
@kishorilalkishoreda5719
Жыл бұрын
Thank you so much for the video, but where do you put the grease?
@rickzirkle4557
6 жыл бұрын
Did you have to disable the SBC braking system
@wakko0hakko
5 жыл бұрын
Yes, he did. * Either using OBDII tool OR * Lock the car and don't open the door for a while before going at the brakes. Opening the door pressurises the SBC system.
@spacyrose6236
Жыл бұрын
Will this work on a sl500 1998
@vectorsigma9903
5 жыл бұрын
Hey Joseph, If you don’t mention how you disabled the SBC system or what kind of scanner you used to do the job what is the point of the video? Without that info you risk major damage or worse. Any chance you can tell us?
@wakko0hakko
5 жыл бұрын
Completely agree - this video only describes 50% of the video, which is generic to most brakes. What he fails to mention is the important point of SBC and disabling it. Out of the 5,900 off views, I hope nobody has messed up the car (or themselves) too bad!
@golfernst
2 жыл бұрын
The calipers probably got stuck on the gouges you put in the rotors with your screwdriver!!!!
Пікірлер: 11