So simple and easy thanks ‼️ Mines just went bad this morning and check engine light came on
@henrylee2964
Жыл бұрын
thanks Steve. I took it to the shop and they found a small leak in one of the hoses but i dont know which hose. 6 months later the DTC code came back so i dont know what is triggering the code this time. There is also a new engine noise. At 10 mph and 1K RPM, I hear a gurgling sound like a turkey was under my hood. I have not found any u-tubers with that symptom.
@darnellsmith4935
5 жыл бұрын
Thanks a lot bro very informative
@toresmoore2024
2 жыл бұрын
U
@jimmytapafini5378
4 ай бұрын
I have no check engine lights on, but my 2012 glk 350 4matic vibrates when i stop the car and doesnt vibrate when i drive it. Any clue on why? I think is the motor mounts, but not sure
@deruin78
Жыл бұрын
I have an S600 and I'm having issues with the fuel precious sensor, canister shut off valve and what you just replaced. I replace every single part with original Mercedes part. The codes were clear off before the parts were replaced and the engine light still coming on with the same codes any suggestion on what is going on?
@jimmytapafini5378
11 ай бұрын
So the code p0456 came on, I changed the fuel cap, no luck, would doing this fix the code???? Any suggestions?
@henrylee2964
Жыл бұрын
why did you change the purge valve? I keep getting a PO456 DTC in my C240. How do i test the purge valve?
@StevenMWilliams0317
Жыл бұрын
It’s a solenoid that can be tested by applying 12 volt to the two leads. If you hear clicking, ten it works. Use test leads from the battery.
@jerrymont2595
3 жыл бұрын
What is that "weird thing" the solenoid connects to and what's its function in relation to the evaporation/emission system?
@besharife
4 жыл бұрын
what does the purge valve do?
@ronaldsurage4392
3 жыл бұрын
Hey brother. What symptoms were you seeing that required you to change the valve can you send me a link to the part and was the issue resolved?
@saadalghamdi3203
4 жыл бұрын
My w220 s350 the gas reutine to tank broblem go out car rear tire smil petrol like explosjion on the line hose . Do you think this valve is broblem .? Thanks deer
@oneemotiva4975
Жыл бұрын
You use clamps , zip ties will break with the heat. They come with pressure Clamps from the factory.
@ethanpn2003
5 жыл бұрын
How do you know purge valve is bad? Is it P0455 gross leak? Thanks
@reyesreyesjr
2 жыл бұрын
Yes PO455 Also check gas cap
@IvanLopez05
4 жыл бұрын
It’s similar to a 2007 model?
@brandontucker2989
5 жыл бұрын
do you know the name of the hose that goes into intake manifold
@gracielaandmadelynandjohan5427
4 жыл бұрын
lm geting po 2240 and po 2237 bank 1 and 2 sensors 1 boths wath can i do on glk 350 2010.
@ntstudio28
3 жыл бұрын
Thank u brother
@unreal2005
2 жыл бұрын
My 2010 glk350 had alot of codes.....and so the fuel tank pressure sensor is bad, gotta drop the gas tank to replace it....and the intake manifold is stuck open or closed, which means the plastic arms broke or the bolt broke, so many of you will probably have these issues too, since its a common problem with these engines.....and lastly, replace the gas cap, that can lead to codes too, and its a cheap fix if a code pops up. I replaced the part in this video, but still throwing the same code, so im stumped.
@arpc0027
22 күн бұрын
But the air intake hose is toast???
@unreal2005
2 жыл бұрын
You will know when this goes bad, when, usually after pumping fuel, it will crank alot before actually starting.
@FixItRyan
2 жыл бұрын
Thanks! Do you know what took is needed to remove the special hose clamps?
@unreal2005
2 жыл бұрын
@@FixItRyan just break them off, and replace with hose clamps
@patsullivan9324
5 жыл бұрын
Thanks bro.!
@KewlQT
2 жыл бұрын
Zip ties! Seriously? Good luck ever trying to replace or work in that area below it ever again. Why not use a couple of hose clamps that you can tighten or loosen off with a flat head screw driver. And no damage to the hoses that removing those zip ties would surely cause (unless you are a highly skilled mechanical surgeon. Peace out.
@mattward4532
5 жыл бұрын
What code does it throw I’m getting PO2422
@mattward4532
5 жыл бұрын
P2422 my bad
@StevenMWilliams0317
Жыл бұрын
P02456
@conniecostalez8433
3 жыл бұрын
same for 2014 c300 sport
@RothBeyondTheGrave
2 жыл бұрын
Different engine
@oneemotiva4975
2 жыл бұрын
Clamps not zip ties
@KewlQT
2 жыл бұрын
2:04 🤮
@hiramperez3330
4 жыл бұрын
I tried this with my c300 and my check engine lights on, I the electric clip is super loose and comes off with a weak tug does it have to do with that?
Пікірлер: 36