There should not be any gasket for the cold start valve, the tip of valve gets seated in the rubber hose coming from your ICV.
@ebutuoyebutouy
2 жыл бұрын
Nice. Thanks for sharing.
@osmantopup288
Жыл бұрын
Very2 nice
@Heve62
6 ай бұрын
Do you know of a 6mm ball in the head? I found one ln my floor after taking the head iff and dont know where it should go :(
@mygermancars7264
6 ай бұрын
Only ball bearing, I know of is next to the fuel distributor it’s inside a tower and you have to cut that top of the tower off to remove the ball bearing to adjust the fuel mixture maybe that ball bearing fell out but in the head I didn’t find any .
@Heve62
6 ай бұрын
@@mygermancars7264 i hope its not from the car.
@mygermancars7264
6 ай бұрын
Is it a M103 engine?
@Heve62
6 ай бұрын
@@mygermancars7264 yes 1988 European. I visited an old mb guy shop and he said Theres no such ball in m103
@gavinmiller6523
9 ай бұрын
I know it's a bit late to ask, but where did you get the bit that you used for the head bolts? I've looked online and I can't seem to find it anywhere.
@mygermancars7264
9 ай бұрын
Napa Auto Parts, 12 Point Allen hardened steel
@dikranberg7600
2 жыл бұрын
OK thank you 😊 🙏 👏 🙂 ☺
@cino4919
Жыл бұрын
Sounds your own intake manifold is restricted 🙃 Short of breath??
Пікірлер: 12