This plays in about 3 sections: 1. video of garage, showing the kit and removal of the old pieces, 2. Wrapping up, 3. Installing the new kit. Methinks sections 2 and 3 are flipped. Or did you install it, remove it and then reinstall it agter greasing?
@madeinlorrainefrederic166
4 жыл бұрын
Another track for my rear vibration problem if it does not come from wheel balancing
@mrtakemytyme7162
4 жыл бұрын
You got mass tools I'm jelly
@kondjanegongo796
4 жыл бұрын
Hi, can you make a video of how to correctly wash/clean your engine bay for W163. Im scared i might damage electronics or alternator, water goes into engine..
@fupabox
4 жыл бұрын
what I do every 6 months is spray an entire can of foaming tire cleaner on the entire engine compartment . (best when engine is warm but not hot ..say idles for 3-4 minutes ) it will make everything look new and protect all the rubber and plastic.a quick wipe afterwards and you won't believe how good it looks . very little work since the foaming cleaner does most of it for you
@kondjanegongo796
4 жыл бұрын
@@fupabox does it remove grease/oil that's baked on? And would u say 60'C is OK?
@fupabox
4 жыл бұрын
@@kondjanegongo796 baked on grease is tough . you want the engine around 80f to make the baked on grease more fluid and gooey . If the grease is really bad use oven cleaner on the really bad parts .. let it sit about 15 minutes and then rinse off with a hose. ..you wont hurt anything under the hood by getting it wet . Then finish off with the foaming tire cleaner to protect and shine all the plastics and rubber hoses.. The foaming tire cleaner will take off minor dirt and grease, but if it's really bad the oven cleaner will do the trick as a first step.
Пікірлер: 9