Ive just done both of mine. If they go you get a loud knocking over bumps
@danielgill2311
Жыл бұрын
Was your noise happening when elecarating
@martinmoffitt4702
Ай бұрын
honestly looks easy enough?
@sflitton2389
Жыл бұрын
Does the upper joint fit flush tight mine won't tighten up flush what am I doing wrong
@sothatsprettyneat
4 жыл бұрын
Did you use a press to get the ball joint all the way flush with the steering knuckle?
@Moldoturk
4 жыл бұрын
No press, just tighten the bolt up
@vitlvitl
6 ай бұрын
Есть номер или артикул съемников ?
@MyNeighborsCar
3 жыл бұрын
is that airmatic suspension on that?
@Moldoturk
3 жыл бұрын
No airmatic
@ZKingof
11 ай бұрын
What kind of clamp ist this ? I want to order one
@Moldoturk
11 ай бұрын
You can get it in a kit on Amazon OMT 5-in-1 Ball Joint Separator, Pitman Arm Puller, Tie Rod End Tool Set for Front End Service, Splitter Removal Kit (RD06) a.co/d/4ISqMf7
@Bossy23
2 жыл бұрын
if you jacked up the control arm, wouldve been easier to get it out... too much tension on it
@Amby0007
4 жыл бұрын
How to do linkage ?????
@thatmatty231guy
3 жыл бұрын
Bryant Erick fuck up
@narcissistinjurygiver2932
3 жыл бұрын
anti seize the new one
@dzitiatri
3 жыл бұрын
I break the fucking new joint bolt in half where . Mercedes you made everything precise, but this place was probably designed by chinese, cause there is no precision and it is hard to see how much to tigthen the bolt with the aligninig pin...
@JKV.
2 жыл бұрын
nice. YOu literally skipped fucking many parts. ty.
Пікірлер: 18