After finishing making a new gear and flat belt pulley from castings that I had poured from patterns I made, I needed to make a custom shaft to mount them to my circa 1890 New Haven Metal Planer. This video will go over the process I used to turn a shaft on the metal lathe and cut keyways on the vertical milling machine so that I could mount these parts to the metal planer.
Support VintageMachinery.org on Patreon:
/ vintagemachinery
Make a one time donation to VintageMachinery via PayPal:
www.paypal.me/...
Please Visit: www.vintagemach...
Sponsored by:
American Rotary Phase Converters
www.americanro...
Use checkout code "Vintage10" for a 10% discount on all AD, ADX and AI converters!
Негізгі бет Metal Planer Restoration 46: Turning a Shaft and Installing a Pulley and Gear
No video
Пікірлер: 180