www.proshaper.com
Our Amazon Storefront:
www.amazon.com...
Metal Shaping for Beginners: Power Shaping
Now Wray shows yet another method to achieve the same results with the fender. We are going to shrink half the panel using 2 inch shrink dies on the Trumpf machine and then use the 4 inch shrink dies on the power hammer. After Wray shrinks the panel he then uses the other half of the power hammer to planish it out. Wray then compares the panel made using the helve hammer to the panel we just made using the Trumpf and Power hammer.
Email: Wray@Proshaper.com
Website: www.proshaper.com
Facebook: / proshaper
Instagram: / proshaper
Twitter: / proshaperm
Linkedin: / proshaper
Негізгі бет Metal shaping for beginners: Power Shaping
Пікірлер: 92