I had the same problem. it turned out that one of the cables that power the brush motor was oxidized. I removed the oxidized piece of cable, soldered it again and everything was fine. Good luck, I hope I helped
@Taxidermist69
Жыл бұрын
I have the same problem, where was the wire oxidized the part that attaches to the motherboard or the part that is connected to the motor?
@user-qo5wf9wu9f
Жыл бұрын
@@Taxidermist69 in my case it had oxidized to the motor.
@Taxidermist69
Жыл бұрын
Hi thanks your solution worked I could not see oxidization because the wire had a plastic wrap near the motor.
@JMJMJM978
7 ай бұрын
Thanks, this worked. For me it was the red cable. It snapped off way too easily after removing the shrink wrapping.
@nasimicin
6 ай бұрын
Thanks for the solution. For me, the red cable to the motor snapped off. I resoldered it, and now it's normal again.
@galerno7060
Жыл бұрын
Hi! How did you fix it? I have the same problem and it got a motherboard swap already, but the problem appeared again after a month. Thanks for you help!
@zureanazainuddin9637
Жыл бұрын
Hi, how did you fix it ? Can you share what sector that you change ?
@zoebrasington4121
Жыл бұрын
Did you manage to clean the brush error?
@selimalkan7632
Жыл бұрын
so how did you fix it ?
@MegaRewop
Жыл бұрын
reclamation... they had to change some "brush sector"
@selimalkan7632
Жыл бұрын
@@MegaRewop thanks...
@rapdimz1180
Жыл бұрын
@@MegaRewop what do you mean by change "brush sector""
Пікірлер: 15