Good video!! I've seen some designs about the crystal oscillator has installed a large ohm(1Mohm or greater) of resistor between pins OSC-IN and OSC-OUT. What is that purpose of the resistor?
@vysmirnov
2 жыл бұрын
It's a feedback resistor. In most of cases this resistor is built-in in chip.
@rayendarwiche
Жыл бұрын
how did you added the pinout from STM32 CUBE IDE into the schematique
@ryanharriss7950
2 жыл бұрын
Good vid. 👍
@AltiumAcademy
Жыл бұрын
Series Playlist is up! Have new ideas for videos or want to make some yourself? Comment below: kzitem.info/news/bejne/lpts33ahhYqkdaQ
@vysmirnov
2 жыл бұрын
It's not necessary to place NoERC on SWO because it's passive type pin.
Пікірлер: 8