Great video! Did you order the additional wiring extensions as well?
@3DayWeekend
10 ай бұрын
Thanks! No, I didn't have to. They all reached to that mounting location, no problem.
@robert100471
2 жыл бұрын
hello , how did these hold up ? great video by the way.
@3DayWeekend
2 жыл бұрын
I've had them about a year now and they are still going strong. No complaints. Thanks for watching!
@remmy73
3 жыл бұрын
All I need now is a razor pro.. nice video. Good wiring diagrams.
@3DayWeekend
3 жыл бұрын
Yes you do! And thanks! 👍
@BengyM
2 жыл бұрын
Great video! Did you run your ground wire from the lights to the frame?
@3DayWeekend
2 жыл бұрын
Thanks! No, the ground wire can go to the ground connection (black) on the Pulse Bar pigtail.
@JordanIvey-f6l
11 ай бұрын
What would be the best way to wire them if I wanted the lights on a switch but wanted it to where I could still have them on with the machine key all the way off.
@dom_offroad
11 ай бұрын
You’d hook the power wire to the switch you have, then wire the switch to constant power 12v. This way the rock lights will be off unless you flip the switch and they’ll turn on whether the key is on or not.
@3DayWeekend
11 ай бұрын
You can connect to the always-on, but look very closely at your switch wiring. If you connect the backlight pin to an always-on source, your battery will drain down. Most switches have a dedicated pin for the backlight (which you would connect to switched power) and a pin for the load (which you would connect to always-on power).
@nathanmcclung658
2 жыл бұрын
Is your wiring diagram located anywhere? Nice install!!
@3DayWeekend
2 жыл бұрын
Just in the video. I just write up a new one for whatever I'm installing or working on each time. I've seen screenshots of this wiring diagram on Facebook though, so I know it's out there. Thanks for watching!
@khateebyounus9712
6 ай бұрын
Hiya mate, what Amp fuse did you use in your circuit?
@3DayWeekend
6 ай бұрын
Hi, there! I'm running a 5 amp fuse in this circuit. The manufacturer claims they run about 4.5 watts per pod. 4.5 x 8 is 36 watts total, divided by 12v, and that gives you about 3 amps of draw. Hope that helps! Thanks for watching!
@MichaelHarris-fg3fk
3 жыл бұрын
Which or what kind of relay did you use? Where can I get one? And are the necessary? Why not just run straight power without a relay? Thanks
@3DayWeekend
3 жыл бұрын
I used a standard 12v relay from a junk car, but you can find them on Amazon. If you do not connect a backlight to your switch, you can run this directly off the red wire on your bus bar, but the lights will not turn off when you turn off the key. If you have a backlight, you'll need to connect to the yellow wire which is only on when the key is on, but the yellow wire does not have enough power to run accessories. Hence the relay. Hopefully that helps clarify...
@doc559
3 жыл бұрын
🏆🏆🏆👍🙏🇨🇱 Thank you for sharing
@user-wp4nm4kt8y
2 жыл бұрын
How may rockers can you run off of one pigtail/relay
@3DayWeekend
2 жыл бұрын
Depends on the amp draw. I wouldn't run more than 20 amps on a single pigtail.
@lilsmith3664
3 жыл бұрын
Bought the same kit of Amazon and received some knock off china crap calling Amazon now
@3DayWeekend
3 жыл бұрын
Well, that's a bummer! Amazon is usually pretty good about fixing that quickly. Hopefully you get the right one soon!
Пікірлер: 24