Do a video on production welding spray and pulse spray. Not too many videos on those processes. Totally different processes and techniques and gases.
@oldgamer1330
4 ай бұрын
Hi, lately when I stop each weld the wire stops too far out so I need to snip it shorter before I start the next weld, do you have any ideas why this would have changed and it there a way to change it. I have tried increasing the tension on the roll hoping it would stop quicker but that did not help. My welder has automatic feed speed control but I always have it set to the minimum anyway so I can't change it there. I have just cleaned out the liner so that is probably why it is running through easier and less drag to stop it at the right stick out but I need to be able to adjust it because I am only doing short welds welding nuts into place so only about 1/2" each weld and it is a pain having to stop and snip the wire after every weld. Thanks.
@VypaGaming
Жыл бұрын
Instead of 45°, I actually find it better to angle the torch roughly in-between 45° and flat to the top plate or piece of metal. About 30°, and point ur welding wire about 1mm away from the gap where the two pieces of metal join together (touching the bottom plate or piece of metal).
@xelaarim
Жыл бұрын
Good Info thanks
@nafisahmad4968
Жыл бұрын
If stick out is only 1/2" then how to look at the puddle?
@sewingwithfirewelding5627
Жыл бұрын
hey Nasif- you need to position yourself around the weld so you can see your puddle at all times. this takes a bit of practice
Пікірлер: 10