Was this the first time running it? Tons of room for improvement.
@cgpmachining
3 ай бұрын
So you use a 5 axis mill so it can clean the pallet off after your done machining the parts?
@wrighty338
3 ай бұрын
i got to the end and realised too 😂
@Eggsr2bcrushed
3 ай бұрын
Yea I'm hammering those out in under 10 minutes on a machine that costs 1/2 as much.
@pr0xxiii243
3 ай бұрын
was this programmed in PowerMill..?
@CVF_RACING
3 ай бұрын
TopSolid
@LilyJiang-y3j
3 ай бұрын
very good😊
@wrighty338
3 ай бұрын
your machine needs a clean....
@CVF_RACING
3 ай бұрын
Agreed!
@mjshorty19
3 ай бұрын
No offense to whoever programmed this, but to have this terribly optimized program running in a robotic cell seems almost criminal. I could make those parts in conservatively, 40% of the time
@wrighty338
3 ай бұрын
I see this often on here and im not even a professional programmer or machinist. There's some process optimisation to be had here i think.
@mjshorty19
3 ай бұрын
@@wrighty338 being a programmer for the last 7 years and only being 29 years old, I'm aware I don't know even close to everything about machining. But I tend to think I know what I am doing relatively well and I would never in my wildest dreams put a program like this out into our shop to run a production part
@CVF_RACING
3 ай бұрын
This video is for customers that have asked to see machined parts in action. To eliminate coolant spray from getting on the camera, sacrifices in speed and efficiency need to be made. We are not trying to show off here 😁
Пікірлер: 13