I bought the same exact saw from Mr. Lucas from justsenditsaws last June. That saw is a frikken beast. Especially living in the northwoods like I do. It absolutely just tears right through the hardwood that we have up here in the upper peninsula of Michigan. I love that the parts are interchangeable with the name brand Stihl.
@majorpixchannel7146
Жыл бұрын
That 660 is a beast 💪! I have a g372xp that I also run on the mill! I have a g288 husqvarna clone and a g880 stihl clone on the way! We are going to try them out on the norwood mill!
@nicholasblohowiak29
Жыл бұрын
@@majorpixchannel7146 I bought my g660 for $375. Mr.Lucas even broke it in for me. The only thing that sucked about it was I had to wait till the middle of October to receive it because of the embargo that was happening off the coast of California. But all in all, super happy about it. I’d love to get the pro model. But my wife said If I were to buy another saw she’d kill me. Lmao. Keep rocking out these awesome videos 👍
@majorpixchannel7146
Жыл бұрын
@@nicholasblohowiak29 The pro's are VERY nice 👌 and thanks... I will be doing daily up loads brother 🙏
@ramoutdoors6415
Жыл бұрын
Nice milling vid man and enjoyed it, thumbs up from Kansas!
@majorpixchannel7146
Жыл бұрын
Thank you good sir 🙏
@Aaron_A_Lynch
Жыл бұрын
That's a pretty saweeet milling set up,🤙🏻🪓😎
@joseleroux7829
7 ай бұрын
Bonjour, superbe vidéo beau travail avec Norwood PM 14
@majorpixchannel7146
7 ай бұрын
THANK YOU 😊🙏 mean a lot!
@tireballastserviceofflorid7771
4 ай бұрын
Got a question. If you measure those planks you cut with calliers. How parallel is the top to the bottom? And how bad if any are the bumps across the surface? We recently bought a used wood kiln. About 1100 foot capacity. Want a band saw mill, but if this cuts true enough for me to plane down. Be a good start on my operation. We are building bee boxes and need a cheap steady supply of wood. So DIY me is going to jump way in over my head...
@majorpixchannel7146
4 ай бұрын
When set up correctly... it cuts as True as a bandsaw mill. It's truly more work and in the long run you are probably better off ordering a hm122 7hp from woodlandmills for about 3k to the door
@jeremyhastings8413
Жыл бұрын
Where did.you get the part the saw mounts too that rides on the ladder rails?
@majorpixchannel7146
Жыл бұрын
It's a norwood pm14 chainsaw mill! You can get them through norwood
@danstihl5137
Жыл бұрын
This thing is very nice! How much does it cost?
@majorpixchannel7146
Жыл бұрын
Thanks... you can order one from norwood for around $1,350 us They are awesome
@josephgray93
5 ай бұрын
Are you using a ripping chain?
@majorpixchannel7146
5 ай бұрын
Yes, granberg ripping chain!! Thanks for watching
@JosephGray-qw4ds
5 ай бұрын
Thanks. I was making sure I was comparing apples to apples.
Пікірлер: 18