Te felicito desde Puerto Rico no sabes cuánto me has alludado
@shannonyoung1207
2 жыл бұрын
you need a special spring compression jig to install springs and this guy installed roller bearings backwards...do not do it like this video or you will have a ruined head
@mehmethussein5048
4 ай бұрын
Love this video slow and with detail 😊
@Supercarlsunday
2 жыл бұрын
Would also love to know the torque spec also.
@hotberitositumorang997
4 жыл бұрын
Mantap videonya pak sukses terus.
@neilhampson2843
9 ай бұрын
It would have been nice to see how you got the valve springs back in the correct location. I did not see in the video how it was done.
@cyberpirate101
3 ай бұрын
how do you install the intermediate shaft properly?
@NeedATank
Жыл бұрын
looked up torque spec and for the N12 engine it shows 10nm for both intake and exhaust cam caps.
@alanw5812
Жыл бұрын
if not because the spring broken, i don't need to remove those bolts to do valve seals or do the head job !
@crisr.9447
3 жыл бұрын
What is the torque specs
@wellwh0
3 жыл бұрын
So it is possible to rebuild head on Prince engines?
@user-xg9me1fd5u
3 жыл бұрын
ЖЭСТАЧАЙШЭ.
@hkr4life
3 жыл бұрын
where can i buy the tools for N18?
@luanrogtina4119
3 жыл бұрын
Was hoping to see how you put the springs back, waste of time
@tonymills9402
3 жыл бұрын
I know, how did he get the springs back behind the intermediate rockers
@AJ-yx7wt
3 жыл бұрын
@@tonymills9402 this is hard part ! its either a tool (like Laser 7120) or a small bar between spring coils, 2 13 or 14mm spanners and a small piece of aluminum behind spanners between coils, and push back. be VERYT careful when winding down the torx bolt (either E6 or8, can't remember), as it is so easy to cross/strip thread (have done this myself :( ). very silly design in my opinion.
@scottybotty7289
3 жыл бұрын
@@AJ-yx7wt or Watch "BMW Mini Peugeot 207 head gasket cam fitment part 1" on KZitem kzitem.info/news/bejne/maOsrXqXnWhmrY4 I honestly found this worked a treat! Simple and effective The cam lifts away with the springs as a complete assembly, no need to release the tension and no need to reinstall (risking cross threading).
@woodcreative9639
11 ай бұрын
Совсем не понятное видео. Нужно рассказывать, по вашему видео можно по разному воспринять действительное
Пікірлер: 21