Beyond helpful! This is just what I was looking for. I got in my 2008 Cooper S for what was symptomatic of a blow head gasket. Had a huge hole burned all the way through cylinder 2.
@TheRedgtv2000
3 жыл бұрын
For the connecting rod bolt torque to yield should be the following: 1- Stage 5Nm 2- Stage 15Nm and 3rd- Stage 130 degrees.
@topdogega4664
3 жыл бұрын
Using the chitons manual is where I got my specs. Which manual are you using? I have had no issues and it’s going on 2 years.
@josegregmartinez5755
3 жыл бұрын
How much were the the piston rings from The dealer ? And did you buy anything else ?
@topdogega4664
3 жыл бұрын
New set of rings (4)if I remember correctly were around 160.00
@topdogega4664
3 жыл бұрын
Purchased new head bolts and new connecting rod bolts. My understanding is they are torque to yield bolts.
@denzelcrocker4956
9 ай бұрын
Did you hone the walls?
@topdogega4664
9 ай бұрын
Yes, I purchased a middle of the road honing tool off of Amazon. Worked great .
@denzelcrocker4956
9 ай бұрын
@@topdogega4664hey me again, you mean the one with 3 Stones right? And did you did the Main bearings to?
@topdogega4664
9 ай бұрын
@@denzelcrocker4956 yes
@JmackDaddyFunk
5 жыл бұрын
It may go smoother if you’re fingers weren’t so fat
@topdogega4664
5 жыл бұрын
JmackDaddyFunk Your probably right! Fat head ,Fat body , fat everything.
Пікірлер: 12