New subscriber I think you did a real good job on that Enjoy the Video We'll be watching again stay safe stay healthy
@CrabTree1
9 ай бұрын
Thanks so much. Really appreciate the feed back. Hoping to put out a new video this week
@RichardDunbar
4 ай бұрын
nice job. thanks for showing the hydraulic pressure adjustment. Going to be doing this on my takeuchi soon. Is there a good pressure testing gauge that you recomend?
@RichardDunbar
4 ай бұрын
Also, does it matter which line you hook the pressure tester to? Which one would be best? Thanks
@CrabTree1
4 ай бұрын
Any gauge will work. i just used a super old one i had laying around in the shop for a long time. Iam sure amazon will have a reasonably priced one
@CrabTree1
4 ай бұрын
Hook it up to the both lines running to the thumb cylinder and test each line for pressure
@ChrisSmith-ls4st
11 ай бұрын
You commented in the video about wishing the thumb closed more ….any thoughts on that now ?
@CrabTree1
11 ай бұрын
Still wishing the thumb closed more for picking up really little stuff but making due with it and getting used to it
@tommyp4728
8 ай бұрын
what wire did you use? on gentecs website they say its made of AR400
@CrabTree1
7 ай бұрын
I used .35 Lincoln wire with aargon and a miller 220 at max with 2 passes.
@bigtimeLL
8 ай бұрын
How did you measure for the thumb and how long is the cylinder?
@CrabTree1
8 ай бұрын
The thumb came as a kit for machine between 3 and 5 ton. I used clamps to hold it on the stick to check for motion as to where it needed to be
@cdmajesty4803
Жыл бұрын
Is that the 30-inch thumb?
@CrabTree1
Жыл бұрын
Its a 24inch
@michaelkoon8371
Жыл бұрын
Sir put a longer cylinder on the thumb
@CrabTree1
Жыл бұрын
Ya I just might in the future. So far it’s seems to working good.
Пікірлер: 19